Environmental Hydrology
Permanent URI for this communityhttps://hdl.handle.net/10413/6541
Browse
Browsing Environmental Hydrology by Subject "ACRU."
Now showing 1 - 3 of 3
- Results Per Page
- Sort Options
Item Assessment of satellite derived rainfall and its use in the ACRU hydrological model.(2017) Suleman, Shuaib.; Chetty, Kershani Tinisha.; Clark, David John.Many parts of southern Africa are considered water scarce regions. Therefore, sound management and decision making is important to achieve maximum usage with sustainability of the precious resource. Hydrological models are often used to inform management decisions; however model performance is directly linked to the quality of data that is input. Rainfall is a key aspect of hydrological systems. Understanding the spatial and temporal variations of rainfall is of paramount importance to make key management decisions within a management area. Rainfall is traditionally measured through the use of in-situ rain gauge measurements. However, rain gauge measurements poorly represent the spatial variations of rainfall and rain gauge networks are diminishing, especially in southern Africa. Due to the sparse distribution of rain gauges and the spatial problems associated with rain gauge measurements, the use of satellite derived rainfall is being increasingly advocated. The overall aim of this research study was to investigate the use of satellite derived rainfall into the ACRU hydrological model to simulate streamflow. Key objectives of the study included (i) the validation of satellite derived rainfall with rain gauge measurements, (ii) generation of time series of satellite derived rainfall to drive the ACRU hydrological model, and (iii) validation of simulated streamflow with measured streamflow. The products were evaluated in the upper uMngeni, upper uThukela (summer rainfall) as well as the upper and central Breede catchments (winter rainfall). The satellite rainfall products chosen for investigation in this study included TRMM 3B42, FEWS ARC2, FEWS RFE2, TAMSAT-3 and GPM. The satellite rainfall products were validated using rain gauges in and around the study sites from 1 January 2010 to 30 April 2017. The rainfall products performed differently at each location with high variation in daily magnitudes of rainfall. Total rainfall volumes over the period of analysis were generally in better agreement with rain gauge volumes with TRMM 3B42 tending to overestimate rainfall volumes whereas the other products underestimated rainfall volumes. The ACRU model was applied using satellite rainfall and rain gauge measurements in the aforementioned study catchments from 1 October 2007 to 30 September 2016. Streamflow results were generally poor and variable amongst products. Daily correlations of streamflow were poor. Total streamflow volumes were in better agreement with total volumes of observed streamflow. TRMM 3B42 and rain gauge driven simulations produced the best results in the summer rainfall region, whereas the FEWS driven simulations produced the best results in the winter rainfall region.Item Development and assessment of an improved continuous simulation modelling system for design flood estimation in South Africa using the ACRU model.(2019) Rowe, Thomas James.; Smithers, Jeffrey Colin.; Clark, David John.An estimate of the risk associated with flood events is required to adequately design hydraulic structures and limit negative socio-economic impacts as a result of floods. The methods used to estimate design floods in South Africa are outdated and are in need of revision. A National Flood Studies Programme (NFSP) has recently been initiated by Smithers et al. (2016) to overhaul Design Flood Estimation (DFE) procedures in South Africa. One of the recommendations of the NFSP is development and assessment of a Continuous Simulation Modelling (CSM) approach to DFE. Consequently, the aim of this study is to further develop and assess the performance of an improved comprehensive CSM system, to consistently and reliably estimate design flood discharges in small catchments (0 - 100 km2) in South Africa using the ACRU model. In the development of the approach a strong emphasis has been placed on ease of use from a practitioner’s point of view. The aim is achieved through several specific objectives as summarised below. The first objective was to review CSM approaches applied locally and internationally for DFE, in order to identify research gaps and guide the development of an improved national CSM system for DFE in South Africa. The review culminates with a list of recommendations and steps required to develop and adopt a CSM approach for DFE in practice. The first critical step identified and required was the development of a comprehensive CSM system using the ACRU model (Schulze, 1995). This included: the structure of the system and how to implement the system, an enhanced land cover and soils classification to apply with the system and default input information and databases to use with the system. The second objective addresses the recommendations made from the literature review, where a comprehensive CSM system for DFE using the ACRU model is developed and described in detail. Based on similarities identified between the ACRU (Schulze, 1995) and SCS-SA models (Schmidt and Schulze, 1987a), as well as the fact that the SCS-SA model is relatively simple and widely applied in practice, the CSM system was adapted to be consistent with the land cover classification used in the SCS-SA model. This included the incorporation of a methodology and rules, developed by Rowe (2015), to represent land management practices and hydrological conditions within the ACRU model. The development of this comprehensive CSM system with default national scale inputs and land cover classifications contributes to new knowledge on how to package a CSM system for DFE in South Africa. The third objective focuses on the assessment and verification of the CSM system developed, using observed data. Through the verifications and assessments performed an inconsistency between daily simulated stormflow volumes and the volume of stormflow used in the daily stormflow peak discharge equation was identified. Therefore, a revision, which is more conceptually correct than the current assumption that all stormflow generated from an event contributes to the peak discharge on the day, was applied to the fraction of the simulated daily stormflow used in the peak discharge equation. This corrected the inconsistency and significantly improved the results, thereby providing an improved methodology to more accurately estimate peak discharges in the ACRU model than had hitherto been the case. Despite the improvement in the results, a general over-simulation of peak discharges was still evident. Consequently, further investigation of the ACRU stormflow peak discharge computations was performed in order to identify which approach provides the most satisfactory results (Objective 4). This included a performance assessment of both the SCS single Unit Hydrograph (UH) approach and the incremental UH approach. The performance of each approach was assessed using both estimated parameters and parameters derived from observed data. These parameters include stormflow volumes, catchment lag times, and the distribution of daily rainfall, where applicable, to each approach. Comparison of the results from the two approaches indicated that more accurate results are obtained when applying the incremental UH approach, when using both estimated or observed parameter inputs. In terms of the incremental UH approach, it was identified that the approach is more sensitive to the use of synthetic daily rainfall distributions compared to estimated lag times. Based on the results obtained new knowledge and additional research gaps related to: (i) improved estimation of the distribution of daily rainfall within the ACRU model, (ii) links between the distribution of daily rainfall and catchment lag time, and (iii) the need to further verify and possibly recalibrate CNs for South Africa were identified. The fifth objective addressed is an assessment of the impact of model configuration on the performance of the ACRU CSM system developed, in order to propose a final CSM system for DFE in South Africa. Results when using site-specific land cover and soils information are compared to those obtained when different sources of input information are used, such as the national land cover and soils maps developed for the entire country. The results when using these default national datasets were not particularly good, however recommendations are made to improve on the results. In addition, the most appropriate current databases to use with the CSM system are defined, providing users with the most appropriate default information currently available to use in the absence of site-specific information. The last objective addressed was a comparison of the performance of the final ACRU CSM system proposed in this study to that of the widely applied SCS-SA model and associated approaches, when using the same input information. Ultimately, the final ACRU CSM system proposed provides results that are superior to those from the SCS-SA model and associated approaches. In addition, several advantages of the ACRU CSM system over the traditional SCS-SA approaches were identified. Recommendations were, however, made to improve on the CSM system developed in this study and to use the results to update the SCS-SA model. New knowledge on the performance of the SCS-SA model and its associated approaches compared to that of the comprehensive CSM system developed for South Africa is therefore provided in this study.Item Development and assessment of rules to parameterise the ACRU model for design flood estimation.(2015) Rowe, Thomas James.; Smithers, Jeffrey Colin.; Schulze, Roland Edgar.; Horan, Mark John Christopher.Design Flood Estimation (DFE) is essential in the planning and design of hydraulic structures. Recent flooding in the country has highlighted the need to review the techniques used to estimate design floods in South Africa, where old and outdated methods are widely applied. In this study the potential of a Continuous Simulation Modelling (CSM) approach to DFE in South Africa is highlighted, identifying the benefits of a CSM approach over event based approaches. The daily time-step ACRU agrohydrological model has provided reasonable results for DFE in several pilot studies. A review on hydrological modelling and the links and similarities between the SCS-SA and ACRU models, however, highlighted that in terms of land cover information, the land cover classification used in the SCS-SA model accounts for different land management practices and hydrological conditions, which are not accounted for in the current versions of the ACRU land cover classification. Since the CNs used in the original SCS model were derived from observations, and the SCS-SA model is an accepted method of DFE in small catchments in South Africa (Schmidt and Schulze, 1987a; Schulze et al., 2004; SANRAL, 2013), it was assumed in this study that the design volumes simulated by the SCS-SA model are reasonable, and that the relative changes in design volumes simulated by the SCS-SA model as a consequence of changes in land management practice or condition are also reasonable. Based on these assumptions, the general approach to the study was to investigate how design volumes simulated by the SCS-SA model for various land management practices or conditions could be simulated by the ACRU model, and to derive classes in the ACRU hierarchical classification for land management practice and hydrological condition. Consequently, design runoff volumes and changes in design runoff volumes, for different management practices and hydrological conditions, as simulated by the SCS-SA model, were used as a substitute for observed data, i.e. as a reference, to achieve similar design runoff volumes and changes in design volumes in the ACRU model. This was achieved by adjusting relevant variables in the ACRU model to represent the change in management practice or hydrological condition, as represented in the SCS-SA model. After three initial attempts failed to produce comparable simulation results between the SCS-SA and ACRU models a sensitivity analysis of ACRU variables was conducted in order to identify which ACRU variables would represent SCS-SA Curve Numbers (CNs) best for selected land cover classes. The sensitivity analysis identified two ACRU variables best suited to achieve this task, namely QFRESP and SMDDEP. Calibration of QFRESP and SMDDEP values against CN values for selected land cover classes was performed. A strong relationship between these ACRU variables and CN values for selected land cover classes was achieved and consequently specific rules and equations were developed to represent SCS-SA land cover classes in ACRU. Recommendations, however, are suggested to further validate and substantiate the approach and developed rules and equations.