The application of pole mounted amorphous core transformers to the electrical distribution network.
Loading...
Date
2017
Authors
Journal Title
Journal ISSN
Volume Title
Publisher
Abstract
With the drive to save money when supplying electricity to customers, utilities are looking
for solutions to decrease losses on distribution lines while maintaining good quality of
supply. Amorphous core transformers are known for having the lower no-load losses
compared to cold rolled grain orientated transformers and hence may be an important
technology to decrease losses on the distribution network. The amorphous material is easily
magnetised, however this comes at the expense of a lower saturation point and the
transformer may need to be designed at a lower peak flux density.
Inrush currents are a phenomenon that occurs when a transformer is switched on. The
combination of the voltage switching angle and the remnant flux lead to an overflux and
subsequent saturation of the core material, this leads to a high current.
The purpose of this dissertation is to investigate the performance of amorphous core
transformers installed on distribution lines, where they are switched onto the network from
the high voltage side, and conclude if they are a suitable replacement for cold rolled grain
oriented steel core.
Inrush currents have been investigated through a circuit model developed in Alternative
Transients Program/Electromagnetic Transients Program (ATP/EMTP) to determine the
currents for various designs of transformers. The model consists of the non-linear component
related to the core used as well as the air core of the high voltage winding. The circuit model
has been validated through an experiment.
A study was undertaken to understand the difference in the forces between amorphous core
transformers and cold rolled grain orientated, this was investigated in Finite Element Method
Magnetics (FEMM) by determining the distribution of magnetic flux. Additionally, as the
inrush current is only seen on the high voltage winding and not the low voltage winding, the
models were compared to the forces due to short-circuit currents, where there is current on
both high voltage and low voltage windings and a different magnetic flux distribution. The
position of the tap winding was of interest as it results in an unsymmetrical force
distribution.
Description
Master of Science in Electrical Engineering. University of KwaZulu-Natal, Durban 2016.